Selfie360 Dolphin 3d Printing Pen Pink


  • reality! It’s also a great way for parents and children to spend quality time together.
    Cute and Handy Dolphin shape design, useful 3d drawing pen toy, its a kind of wonderful gift for kids birthday.
  • Low temperature protection: you can draw on your hands directly. This 3d pen work with PLA filament, much lower working temperature than normal filament 3d pen, safer for kids.
  • Built-in battery : Fast boot setup in just around 30 seconds gets you drawing and creating quickly. It can work for around 1 hour after 30 minutes charge. Convenient and light to carry.
  • This 3D printing pen is very easy to use for kids. Control it with just 2 buttons. There is an automatic feed to help hand fatigue. Just press the function button and start doodling! PLA, ABS filament was supported. Comfortable for the hands for both children and adults.
Category: Product ID: 5006


Operation Instructions
[Start Up]

Please keep pressing the “ON/OFF Button” for 2 seconds, then the LED red light is slowly flash, and the hot plate begins to preheat(when preheating, the function control cannot operate). Preheat about 20s , LED light turns green, the product into the working state.

Product Name : Dolphin 3D printing pen
Mobile Power Supply 5V-2A
Product Rated Voltage DC3.7±0.25V
Filament material PCL 1.75mm
Printing Temperature 55℃~75℃
Working Conditions 10℃~35℃/ Relative Humidity≤85%
Loading material mode Click to feed/click to stop


There are no reviews yet.

Be the first to review “Selfie360 Dolphin 3d Printing Pen Pink”

Your email address will not be published.